This is just a simple XL/XE PBI/ECI breakout pcb so that you can access signals easier.
This is the only part you need for the XL PBI Breakout PCB. Only one. If you contact the seller he might be willing to sell in smaller lots.
50x Card Edge Connector 25x2P 2.54mm 240-50
These are the two parts you need for the XE ECI Breakout PCB. One of each.If you contact the seller he might be willing to sell in smaller lots.
These two versions of the 130XE RA Extension boards allow the user to re-orientate the cartridge vertically rather than horizonatally. One is just a simple RA orientation of the cartridge slot and the other is a full ECI RA orientation
This is the only part you need for the 130XE RA Cart PCB. Only one. If you contact the seller he might be willing to sell in smaller lots.
10x Card Edge Connector 15x2P 2.54mm 240-30
This is the only two parts you need for the 130XE RA Full ECI bus PCB. One each. If you contact the seller he might be willing to sell in smaller lots.
This pcb will allow PBI devices designed for the 800XL to be connected to an Atari 130XE Not all PBI devices will work, but most should.
Signal CASinh needs to be hardwired from 130XE Freddie pin 4 to ECI reserved pin A internally, Signals HALT, $D1xx, RD5 and CASinh are hardwired to PBI pins 33, 37, 39 and ENTNB respectively on the adapter. RDY needs to be hardwired from 130XE ANTIC pin 15 to RDY single pin on adapter.
These are the only three parts needed for the XE ECI to XL PBI Single Cart adapter PCB
10x Card Edge Connector 15x2P 2.54mm 240-30